The watch was too small and they turned the forearm into a trackpad.

📅 2026-11-16

Abstract:

The research team at North Carolina State University made a radar wristband. After putting it on, the forearm becomes the trackpad of the watch. When your fingers point and draw on it, the watch can receive corresponding instructions. However, it is still a prototype, and the circuit board on the wristband is exposed.

The screen of the watch is inherently small. When zooming on the map or clicking a button that is only a few millimeters long, it is often difficult to press it accurately with your fingers. The idea behind this wristband is to

move the input area to the arm

, the area that can be pressed is widened instantly.

It relies on millimeter-wave radar to see the skin. When a finger is pressed on the forearm, the skin will be slightly deformed. The radar captures these changes, and the software relies on machine learning to figure out which finger, where and how to move it.


The entire sensor array is only 5 mm x 4 mm. There is no need to attach anything to the forearm. One calibration takes 3 minutes and 54 seconds. After that, the accuracy of gesture recognition is 92.8%.

There were 20 people in total in this group of tests, and these numbers were measured on people who had never seen this system.

The pressing force can distinguish 90.2%, and the ranging accuracy is 10.2 mm.


As for the cost, the team estimated the cost of components, which is less than 10 US dollars. It can be even lower if the quantity is large. This is not the price that can be purchased.

Kuai Technology checked the school's press release and learned that the 20 people were tested with real clothes, not computer simulations. The paper was published in PACM IMWUT, a peer-reviewed journal.

Related tags

Related articles

Comments

0/500
Captcha (click to refresh)
No comments yet